Brother MFC-5860CN Network User's Manual page 42

d
Verify that the print server is on your network as follows:
®
For Windows
Try pinging the print server from the host operating system command prompt with the command:
ping ipaddress
Where ipaddress is the print server IP address (note that in some instances it can take up to two
minutes for the print server to load its IP address after setting the IP address).
®
For Mac OS X 10.2.4 or greater
1
From the Go menu, select Applications.
2
Open the Utilities folder.
3
Double-click the Printer Setup Utility icon. (For Mac OS
Print Center icon)
4
Click Add.
5
Make the following selection. Make sure that your print server appears. If it is visible, then the
connection is good. Otherwise, go to e.
®
(Mac OS X 10.2.4 - 10.3.x)
e
If you have tried 1 to 4 above and it does not work, then reset the print server back to the default factory
settings and try from the initial setup again. For information how to reset to the default factory settings,
see Restoring the network settings to factory default on page 25.
f
Check the following.
®
For Windows
If the installation failed, the Firewall on your computer may be blocking the necessary network
connection to the machine. In this case, you will need to disable the Firewall on your computer and
re-install the drivers.
®
X 10.2.x users, double click the
(Mac OS
7
Troubleshooting
®
X 10.4)
7
7
36