Disconnecting The Cable - Datalogic QuickScan QD2590 Quick Reference Manual

Setting Up the Reader

Disconnecting the Cable

To remove the interface cable from the reader, first locate
the hole on the bottom of the handle. Next, take a paper
clip and modify it as shown in the figure below. Insert the
end of the paper clip into the hole and press it to push on
the clip that holds the connector. As you apply pressure,
pull out the cable.
When reinserting the cable, make sure the connector clip
is on the same side as the reader release hole. Insert the
cable, it should click when it is fully inserted.
5
QUICK REFERENCE GUIDE