Scanning A Document Into The Pc (Dcp-7010L, Dcp-7025, Mfc-7420 And Mfc-7820N Only) - Brother DCP-7010L Software User's Manual

®
How to scan using Windows
Scanning a document into the PC
(DCP-7010L, DCP-7025, MFC-7420 and MFC-7820N Only)
There are two ways in which you can scan a whole page. You can either use the ADF (automatic document
feeder) or the Flatbed scanner glass. (ADF is not available for DCP-7010L.)
If you would like to scan and then crop a portion of the page after pre-scanning the document, you will need
to use the scanner glass (Flatbed). (See Pre-Scanning to crop a portion you want to scan on page 2-9.)
Scanning a document using the ADF (not available for DCP-7010L)
1
Load your document.
2
Select the Document Feeder from the Paper source
drop-down list box (A).
3
Select the picture type (B).
4
Select the Paper size from the drop-down list box (D).
5
If you require advanced settings, click on the tab Adjust
the quality of the scanned picture (C). You can select
Brightness, Contrast, Resolution and Picture Type
from the Advanced Properties. Click the OK button
after you choose your settings.
Note
■
You can select a resolution of up to 1200 dpi.
■
For resolutions greater than 1200 dpi, use the Brother Scanner Utility. (See Brother Scanner Utility (not
available for MFC-7225N) on page 2-6.)
6
To start scanning your document, click the Scan button in the Scan dialog box.
A
B
C
D
2
2 - 4