Connection Procedure; Work Flow - Omron NJ Series Network Connection Manual

7. Connection Procedure

This section describes the procedure for connecting the RFID Reader/Writer to the Controller
via Ethernet.
This document explains the procedures for setting the Controller and RFID Reader/Writer
from the factory default setting. For the initialization, refer to Section 8 Initialization Method.

7.1. Work Flow

Take the following steps to connect the RFID Reader/Writer to the Controller via Ethernet.
7.2 Setting Up the RFID Reader/Writer
↓
7.2.1 Parameter Setting
↓
7.3 Setting Up the Controller
↓
7.3.1 Starting the Sysmac Studio and
Importing the Project File
↓
7.3.2 Checking the Parameters and
Building
↓
7.3.3 Connecting Online and
Transferring the Project Data
↓
7.4 Connection Status Check
↓
7.4.1 Executing the Program and
Checking the Receive Data
Precautions for Correct Use
Prepare the latest project file in advance.
To obtain the file, contact your OMRON representative.
7. Connection Procedure
Set up the RFID Reader/Writer.
Set the parameters of the RFID Reader/Writer.
Set up the Controller.
Start the Sysmac Studio, and import the project file.
Check the set parameters, execute the program
check on the project data and build the Controller.
Connect online with the Sysmac Studio and transfer
the project data to the Controller.
Execute the program and confirm that Ethernet
communications are normally performed.
Execute the program and confirm that the correct
data are written to the variables of the Controller.
11