Ethernet Communications Settings - Omron NJ Series Network Connection Manual

6. Ethernet Communications Settings

This section describes the specifications such as communication parameters and variables
that are set in this document.
Additional Information
To perform communications without using the settings described in this section, you need to
modify the program. For information on the program, refer to Section 9. Program.
6.1. Ethernet Communications Settings
The settings required for Ethernet communications are shown below.
6.1.1. Communications Settings between the Personal Computer and the RFID
Reader/Writer
The setting example below is used to explain the procedure for setting the RFID
Reader/Writer by using the personal computer.
Setting item
IP address
Subnet mask
Gateway
*In this document, the gateway setting is unnecessary because the connection is made in
the same segment.
6.1.2. Communications Settings between the Controller and the RFID
Reader/Writer
The setting example below is used to explain the procedure for connecting the Controller to
the RFID Reader/Writer.
Setting item
IP address
Subnet mask
Gateway
Host name
Domain name
DHCP
TCP/IP port
*In this document, the gateway setting is unnecessary because the connection is made in
the same segment.
*This project file uses the default settings (keep-alive: use, linger option: Do not use) of the
keep-alive and linger option functions for the TCP socket communications. Use these
functions according to the system when necessary.
Personal computer used for setting
192.168.1.1
255.255.255.0
---.---.---.---
NJ501-1500
192.168.250.1
255.255.255.0
-.-.-.-
-
-
-
(This is set by the program.)
6. Ethernet Communications Settings
RFID Reader/Writer
192.168.1.200 (Default)
255.255.255.0 (Default)
192.168.1.254 (Default)
RFID Reader/Writer
192.168.250.2
255.255.255.0 (Default)
192.168.1.254 (Default)
"V750-BA50C04-US" (Default)
Blank (Default)
OFF (Default)
7090 (Default)
9