Table of Contents
Advertisement
Available languages
Available languages
EN
Close the milk whipping jug and fit it into the
machine.
If the milk frothing jug is correctly positioned, the
machine will give out a beeping sound.
When the milk frothing jug has been inserted, the
machine will only enable the milk-based selec-
tions. The coffee icons will be disabled.
Press the LATTE "MILK"
the cleaning cycle.
After cleaning, remove the jug from the ma-
chine.
Wash all the components with cold or warm
water, then dry them up and fit them back into
place correctly.
10
PREPARING THE MACHINE
supply key to start
PREPARATION FOR COFFEE BREWING
Coffee brewing only: remove the milk frothing
jug from the machine.
When the milk frothing jug is not inserted, the
coffee dispensing icons will turn on only.
The milk dispensing icons will be disabled.
The following coffee dispensing supply keys will
light up to a steady white light.
Espresso
selection
"
"
Lungo
Weak
selection
Coffee 8 oz.
selection
Double shot coffee (only espresso)
The coffee machine features two positions, for
espresso cup or big cup (or glass) respectively.
• To use a big cup, place the mug (or glass)
directly onto the plate at the bottom.
• To use an espresso coffee cup, you can
remove the cup support plate.
Fit the cup support plate into the slot available
at the top, then place the espresso coffee cup
onto the plate.
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the CLASSY PLUS and is the answer not in the manual?
Questions and answers
The orange light for water tank removed is on but the water tank is in place. When I turn on and off it is not on but when I try and brew the light comes back on and will not brew.
The orange light for the water tank on the LAVAZZA CLASSY PLUS may be on even when the water tank is in place due to the following reasons:
1. No water in the tank – Ensure the tank is filled with fresh drinking water.
2. Tank not inserted correctly – Remove and correctly reinsert the water tank.
3. No water flow in the hydraulic circuit – Disconnect the power cord, wait 10 seconds, reconnect it, and turn the machine on. Wait for the heating cycle to complete, as the machine will automatically attempt to fill the hydraulic circuit.
If the issue persists, contact Lavazza Customer Service.
This answer is automatically generated