Connection - GE ApexPro Operator's Manual

Equipment setup

Connection

3-12
The patient cable, microphone cable, and interconnection cable are attached to one
another in one assembly. See Interconnection cables on page 3-10.
blood pressure monitor, follow this procedure:
1. Attach the brass end of the patient cable to the brass air hose connector on the
side of the monitor.
2. Connect the microphone cable to the 6-pin connector on the side of the monitor,
near the air hose connector.
1
2
3
4
5
3. Secure the cable by screwing on the metal cable cap, then insert the monitor into
the nylon pouch.
4. Attach the blood pressure cuff hose to the white plastic fitting on the patient
cable. Turn the fitting to the right approximately one quarter turn. Some
connector models will click when they are connected. Make sure that it is
ApexPro™
4
5
Microphone cable connection
Patient connection cable
ApexPro transmitter interconnection cable
Blood pressure cuff connection cable
Microphone cable
To connect the
1
2
3
2001989-200E
407A
411A