GE ApexPro Operator's Manual page 78

Alarms
5-10
Click the (close button) on the top right side of the window to close the
window.
5. A message window with the information regarding the last change made. Select
Yes to accept the change or No to cancel the change.
Adjusting the alarm levels
WARNING
ALARM CONTROL SETTINGS—If you adjust parameter limits or
alarm levels at the CIC Pro center, these setting changes are also
implemented by the bedside monitor. You must notify the bedside
caregiver that you changed the parameter limit or alarm levels of
that bedside monitor.
1. From the Alarm Control window, click on the alarm Level field.
2. Click the down arrow to display a list of alarm levels.
3. Select the desired alarm level.
4. Repeat step 1 to step 3
5. After making your selections, complete one of the following tasks:
Choose a different control setting to adjust.
Click the (close button) on the top right side of the window to close the
window.
6. A message window with the information regarding the last change made. Select
Yes to accept the change or No to cancel the change.
Adjusting telemetry Alarms On/Off control settings
WARNING
Alarms do not sound, alarm histories are not stored, and alarm
graphs do not print during an alarms off with reason condition.
NOTE
The patient must be in antenna range for the alarm pause state to cease. After the
patient has returned to antenna range and/or alarms have been turned back on,
verify that the patient's waveforms are displayed at the CIC Pro center or bedside
monitor
NOTE
Refer to Alarm pause breakthrough on page 5-6
information.
The telemetry Alarm Pause - Smart Alarms feature reduces false patient alarms and
works as follows:
When a patient is re-connected to the telemetry device and continuous ECG data
is recorded, the alarm pause condition automatically clears.
ApexPro™
to adjust additional alarm level settings.
for important alarm pause
2001989-200E