Source Audio Ultrawave User Manual page 34

Like all Source Audio One Series pedals, the Ultrawave is fully supported in the Neuro Mobile app.
The Neuro Mobile app is available for iOS and Android devices and allows access to all of the preset
parameters and hardware options described in the Neuro Desktop editor section above.
Connecting to the Neuro Mobile App (USB-MIDI)
The Ultrawave is the second Source Audio pedal after the EQ2 to add two-way communication with
the Neuro Mobile app using MIDI over USB. This means that any changes made on the pedal are
immediately reflected in the app and that the app always reflects the actual current state of all the
pedal's parameters, rather than the one-way audio connection to Input 2, where the Neuro App is
only able to send signals and not receive any. To connect the Ultrawave to the mobile device you will
need the proper cable adapters.
•
iOS Devices – Any iOS device with a lightning connector is supported. A "Lightning to USB
Camera Adapter" is required. Connect the adapter to the USB A/B-mini cable that was
included with your Ultrawave.
•
Android Devices – Android devices may have either USB-micro or USB-C connectors that will
support MIDI over USB communication with the Ultrawave. You will need the appropriate
USB B/C (male) to USB A (female) adapter to use with the included USB A/B-mini cable. Note
that the USB B-micro to USB A adapter is sometimes called an OTG (On-The-Go) adapter.
Connecting to the Neuro Mobile App (headphone jack)
The Ultrawave also supports one-way communication between a mobile device and the pedal using
the included TRS ¼" to
Lightning dongle for Apple devices) of your mobile device and Input 2 of the Ultrawave. The cable is
a TRS (stereo) connector that uses the "Right" channel to send data over audio signals to the pedal.
When using the headphone jack connection, we recommend using the Volume Calibration features
in the Neuro Mobile app to configure the audio output for the most reliable communication between
the mobile device and pedal.
Table of Contents
1
⁄ " cable. Connect the cable to the headphone jack (or headphone to
8
Ultrawave Multiband Processor User Guide 34