Restore Settings; Hmi Update; External Epm Set; Restart Hmi - SOLIS -100K-5G Installation And Operation Manual

7. Normal operation
7.5.8.1 Enable logic interface settings
Please follow below settings to enable the DRM. DRM default setting is "OFF" , if DRM set "ON",
but the logic interface un-connected to the switch or the switch is open, the inverter HMI will
display "Limit by DRM" and the inverter output power will be limited to zero.
1. Select Initial Settings
2. Select DRM and set it "ON"

7.5.9 Restore Settings

There are 5 items in initial setting submenu.
Restore setting could set all item in 7.5.7 special setting to default.
The
screen
shows
as
below:
Are you sure?
YES=<ENT> NO=<ESC>
Figure 7.21 Restore Settings
Press
the
Enter
key
to
save
the
setting
after
setting
grid
off.
Press
the
ESC
key
to
return
the
previous
mean.

7.5.10 HMI Update

This section is applicable to maintenance personnel only.
Selecting "Updater" displays the sub-menu shown below:
HMI Current Ver.: 02
YES=<ENT> NO=<ESC>
Updater is for updating LCD firmware. Press the ENTER key to start the process.
Press the ESC key to return to the previous menu.
.44.
Figure 7.22
7. Normal operation

7.5.11 External EPM Set

This function is turned on when the EPM is external.
YES=<ENT> NO=<ESC>
Fail Safe Set:ON
Figure 7.23 Set the Fail Safe ON/OFF

7.5.12 Restart HMI

The
function
is
used
for
restart
the
HMI.
This function is applicable by maintenance personnel only, wrong operation
will prevent the inverter from reaching maximum power.

7.5.13 Debug Parameter

This section is applicable to maintenance personnel only.
Debug Parameter as shown as below:
→
S16DAT1: +0000
S16DAT2: +0000
Press the UP/DOWN keys to scroll through items. Press the ENTER key to select.
Press the DOWN key to scroll and press the UP key to change the value.
Press the ENTER key to save the setting. Press the ESC key to cancel.
changes and return to the previous menu.

7.5.14 FAN Test

This section is applicable to maintenance personnel only.
Figure 7.24
.45.