Table of Contents
Advertisement
4.
Transport and storage
Observe the instructions in section 3, "Safety instructions"!
4.1
Scope of supply
The products supplied are listed in the despatch papers. Check immediately on receipt to ensure that all
the products listed have actually been delivered. Parts damaged and/or missing parts must be reported
to Siemensin writing immediately.
If there is any visible damage, the gear unit must not be put into operation.
4.2
Transport
When transporting Siemens products, use only lifting and handling equipment of
sufficient loadbearing capacity!
Observe the notes regarding load distribution on the packing. While being transported
on vehicles, loads must be properly secured as required by the regulations.
The gear unit is delivered in the fully assembled condition. Additional items are delivered separately
packaged, if applicable.
Different forms of packaging may be used, depending on the size of the unit and method of transport.
Unless otherwise agreed, the packaging complies with the HPE Packaging Guidelines.
The symbols marked on the packing must be observed at all times. These have the following meanings:
Top
Fig. 2:
Transport symbols
Transport of the gear unit must be carried out so as to avoid personal damage and
damage to the gear unit.
If, for example, the free shaft ends are knocked, this may damage the gear unit.
The gear unit must be transported using suitable equipment only. During transport the gear unit
should be left without oil filling and on the transport packing.
When transporting the gear unit, use only the transport eyes and/or transport lugs
provided to attach slinging and lifting equipment to the gear unit.
The pipework must not be damaged.
Do not use the front threads at the shaft ends to attach slinging and lifting gear for
transport.
Slinging and lifting gear must be adequate for the weight of the gear unit.
Fragile
Keep dry
BA 5200 EN 08/2010
Keep cool
Centre of
gravity
16 / 65
Use no hand
Attach
hook
here
Advertisement
Table of Contents
