Fitting With Red­bronze Bush; Axial Fastening - Siemens REDUREX Assembly And Operating Instructions Manual

Gear unit
Table of Contents

Advertisement

6.5.1.1 Fitting with red­bronze bush
Fit the gear unit by means of nut and threaded spindle. The counterforce is provided by the hollow shaft.
The hollow shaft must be exactly aligned with the machine shaft to avoid canting.
When fitting, ensure that the position of the teeth between the machine shaft and
hollow shaft is correct. The correct position can be determined by turning the input
shaft or by swivelling the gear unit lightly around the hollow shaft.
7
5
6
Fig. 17: Hollow shaft, fitting with red-bronze bush
1
Machine shaft
2
Hollow shaft
3
Red­bronze bush
Instead of the nut and threaded spindle shown in the diagram, other types of equipment such as a hydraulic
lifting unit (type "Lukas") may be used.
The shaft must be pulled smartly into the hollow shaft as far as the end plate.
The hollow shaft may be tightened against a machine­shaft collar only if the gear­unit
configuration is one of the following:
­ Torque arm
­ Support with gear­unit swing base
With a different arrangement the bearings may be excessively stressed.

6.5.1.2 Axial fastening

If the shrink disk is fitted according to instructions (see item 6.6), the gear unit is fixed securely in the axial
direction. Additional axial fastening is not required.
4
Nut
5
Threaded spindle
6
Nut
BA 5200 EN 08/2010
37 / 65
2
4
7
End plate
3
1

Advertisement

Table of Contents
loading

Table of Contents