Table of Contents
Advertisement
10.
Maintenance and repair
Observe the instructions in section 3, "Safety instructions", and in section 9, "Faults, causes and remedy"!
10.1
General notes on maintenance
All maintenance and repair work must be done with care and by duly trained and qualified personnel only.
The following applies to all work in item 10.2:
Switch the gear unit and addon components off.
Secure the drive unit to prevent it from being started up unintentionally.
Attach a warning notice to the start switch!
The periods indicated in table 13 depend on the conditions under which the gear unit
is operated. Only average periods can therefore be stated here. These refer to:
The operator must ensure that the intervals stated in table 13 are adhered to.
This also applies if the maintenance work is included in the operator's internal
maintenance schedules.
Table 13: Maintenance and repair work
Maßnahmen
Check oil temperature
Check for unusual gearunit noise
Check oil level
Check gear unit for leaks
Test the water content of the oil
Perform the first oil change
Perform subsequent oil changes
Clean the oil filter
Clean the breather screw
Clean the gear unit
Clean fan and gear unit
Refill Taconite seals with grease
a daily operating time of
a duty factor "ED" of
an inputdrive speed of
Operating temperature of
Daily
Daily
Monthly
Monthly
After approx. 400 operating hours,
at least once per year
Approx. 400 operating hours
after startup
Every 24 months or
10000 operating hours
Every 3 months
Every 3 months
Depending on requirements,
at least every 2 years
Depending on requirements,
at least every 2 years
Every 3000 operating hours
or at least every 6 months
BA 5200 EN 08/2010
57 / 65
24 h
100 %
1500 1/min
90 °C (mineral oil only)
Fristen
‐ Middle of the oilsight glass
Top mark on the oil dipstick
see item 10.1.1
see item 10.2.2
see item 10.2.2
see item 10.2.2
see item 10.2.3
See item 10.2.4
see item 10.2.5
see item 10.2.6
Bemerkungen
Advertisement
Table of Contents
