Table of Contents
Advertisement
Table 9:
Molykote G Rapid
Aemasol MO 19 P
1)
Other lubricants may be used if they have the same characteristics.
•
Join inner ring (3) and outer ring (4).
•
Place the tensioning bolts and screw in some threads by your fingers.
Observe the manufacturer's instructions for handling lubricants!
Mounting and startup must be carried out by properly trained specialist personnel.
6.6.4
Remounting the shrink disk
For remounting the shrink disk the procedure described in item 6.6.1 must be adhered to.
6.6.5
Inspection of the shrink disk
In all cases the inspection relating to the shrink disk should be carried out simultaneously with
the examination of the gear unit, however at least every 12 months.
Inspection of the shrink disk is limited to a visual assessment of its condition. The following must be
observed when carrying out this work:
─ loose screws
─ damage caused by force
─ flush position of the inner ring (3) in relation to outer ring (4)
6.7
Couplings, clutches
As a rule, flexible couplings or safety slip clutches are provided for the drive of the gear unit.
If rigid couplings or other in and/or output elements, which create additional radial and/or axial forces,
(e.g. gear wheels, belt pulleys, disk flywheels, hydraulic couplings) are to be used, this must be agreed by
contract.
Couplings must be balanced in accordance with the specifications in the pertinent
instructions manual!
For maintenance and operation of the couplings, refer to the specific operating instructions for
the couplings.
When installing the drives, make absolutely certain that the individual components are
accurately aligned in relation to each other. Inadmissibly large errors in the alignment
of the shaft ends to be connected due to angular and/or axial misalignments result in
premature wear and/or material damage.
Insufficiently rigid base frames or substructures can also during operation cause
a radial and/or axial misalignment, which cannot be measured when the unit is at
a standstill.
For permissible alignment errors in the case of couplings supplied by Siemens, please refer to
the operating instruction manuals for the couplings.
If you use couplings manufactured by other manufacturers, ask these manufacturers which
alignment errors are permissible, stating the radial loads occurring.
Recommended lubricants for shrink disks after their cleaning
Lubricant
Unimoly P 5
gleitmo 100
BA 5200 EN 08/2010
Form
Spray or paste
Spray or paste
Powder
Spray or paste
41 / 65
1)
Manufacturer
DOW Corning
A. C. Matthes
Klüber Lubrication
Fuchs Lubritec
Advertisement
Table of Contents
