FujiFilm CX 3240 User Manual page 194

Problem Solving
027-735
027-736
027-757
11
027-758
027-759
027-760
194
Error Code
[Cause] The data transfer using SSL is specified, but the SSL setting
[Remedy] Enable the SSL setting, or specify HTTP for the transfer
[Cause] The server certificate verification feature of the printer is
[Remedy] Enable the server certificate validation. Or, disable the server
[Cause] Probable causes are as follows:
[Remedy] For 1), check connection between the printer and the server,
[Cause] The LDAP server sent back RFC2251 Result Message No
[Remedy] Make sure the login name and password are correctly set in
[Cause] The connection to the LDAP server specified in the LDAP
[Remedy] Make sure the network settings of the printer are correctly set.
[Cause] An invalid parameter is specified by XJT command.
[Remedy] Confirm the specified parameter.
Cause/Remedy
of the printer is disabled.
protocol.
disabled when the server certificate verification is required.
certificate validation for data transfer.
1. An error occurred while connecting the server.
2. The reliable certificate has not been registered on the
printer.
3. The server addresses of the SSL server and the destination
server are not same.
4. The printer tries to communicate with the server using the
encryption method which is not supported on the printer.
5. The SSL client certificate has not been registered on the
printer.
6. The server certificate has been expired or will be expired
soon.
or the printer and the DNS server using ping or trace route.
For 2), import the CA certificate and intermediate certificate
reliable to the SSL server to the printer.
For 3), check whether or not the printer communicates via the
SSL proxy server which enables you to confirm the SSL
communication. When the printer uses the server, set the
printer not to use the SSL proxy server.
For 4), check the encryption method supported on the printer.
Set the available encryption method to the SSL server setting.
For 5), import the SSL client certificate and configure the
setting to use the certificate.
For 6), check the date and time registered on the printer is
precise. If they are not, adjust the gap.
"49" (invalid credentials).
the LDAP server/directory settings. If the same message is
displayed again, contact your local dealer.
server/directory settings failed.
If the same message is displayed again, consult the network
administrator and check the connection from the printer to the
server.