XFP 16 ZONE ANALOGUE ADDRESSABLE FIRE ALARM PANEL
Display Fire Events
This function is only available if there are active fire conditions on the system. If available, press the
4
Accept
button and a window similar to the one below will appear:
Last Zone: 1:North Stairs
5
Pressing the
and
information (if applicable) can be viewed by pressing the panel's More Information button. To return
to the main access level 3 menu press the Escape
Display Fault Events
This function is only available if there are active faults on the system. If available, press the Accept
button and a window similar to the one below will appear:
Zone 1: Ground Floor
There are faults on this zone
5
Pressing the
and
information (if applicable) can be viewed by pressing the panel's More Information button. To return
to the main access level 3 menu press the Escape
Display Disablements
This function is only available when there are active disablements on the system. If available, press
4
the Accept
button and a window similar to the one overleaf will appear:
1st Zone: 1: Shop floor
On: This Panel: Is Disabled
5
Pressing the
and
information (if applicable) can be viewed by pressing the panel's More Information button. To return
to the main access level 3 menu press the Escape
Display Zones In Test
This function is only available if one or more zones are being tested. If available, press the
4
Accept
button and a window similar to the one below will appear:
Zone 1: North Stairs
Is On Test
5
Pressing the
and
information (if applicable) can be viewed by pressing the panel's More Information button. To return
to the main access level 3 menu press the Escape
Setup Passwords
This function allows you to change the four digit access codes required to activate the panel's access level
2 or 3 menu options. When selected, press the Accept
CHANGE ACCESS LEVEL 2 CODE?
Change Access Level 3 code
5
6
Use the
and
buttons to scroll to the desired option (the option in block capitals is the selected
option) and press the Accept
LEVEL 2 CODE? prompt is accepted.
Enter NEW Access Level 2 code:
5
4
Using the
(1)
(2)
digit has been entered, the panel will request you confirm the new code by re-entering it:
XFP ENGINEERING MANUAL • Approved Document No. DFU1200510 Rev 3 • Page 19 of 36
:Fire!
1 Zone
6
buttons will scroll the display through all active fire conditions. More detailed
6
buttons will scroll the display through all active faults. More detailed
6
buttons will scroll the display through all active disablements. More detailed
6
buttons will scroll the display through all zones currently in test. More detailed
4
button. The following message will appear if the CHANGE ACCESS
6
3
(3)
(4) buttons, enter the new four digit access level 2 code. After the fourth
3
button.
3
button.
3
button.
3
button.
4
button and the following window will appear:
4