Table of Contents
Advertisement
PCI 1 Port RS422/485
Windows NT 4.0 Installation.
Microsoft Windows NT Provides built in support for 255
standard serial ports. To setup your PCI RS422/485 serial card you
should follow these steps. Please note that to change any kind of
hardware configuration under Windows NT you must be logged in
as a user with Administrator level privileges, if you do not have
these please contact your system administrator.
Software Installation.
Insert the PCI 1 Port Velocity RS422/485 into your PC, as
described in chapter 2, and restart. Place the supplied CDROM
titled "Serial Solutions Software" in a suitable drive and from the
Start Menu choose Run and enter
<drive>:\diskimg\ssnt\setup (where <drive>: is the
path to the CDROM drive containing the installation disk).
InstallShield will then install the driver software automatically -
it will then copy the necessary files and start itself. This
automatically detects your new PCI serial card(s) and does not
require any further system restarting.
Chapter 3 Page 47
Software Setup
Advertisement
Table of Contents
