Rs485 Many Talkers- Many Listeners, Full Duplex - Brainboxes CC-324 User Manual

Brainboxes cc-324 pci cards: supplementary guide
Table of Contents

Advertisement

PCI 1 Port RS422/485

RS485 Many Talkers- Many Listeners, Full Duplex.

The RS485 many talkers, many listeners, Full Duplex
system can be used when all the RS485 devices have separate
Transmit and Receive channels. There is NO multiplexing of the
TXD and RXD signals on the same device. This system is
especially useful when there is no flow control available on the
PC, usually due to the use of a third party communications
program that prevents the use of the RTS signal as a "transmit
enable" control, via the TXD GATE jumper. It can be used in the
following situations:-
a)
The PC is connected to only ONE RS485 device.
b)
The PC is communicating with several RS485 devices that
are each able to recognize and respond to their own unique
address.
when they are responding to requests from the PC to send data. In
effect, the RS485 device's address and the command it receives is
used to control access to the devices TXD channel.
This is a Full Duplex system. Two twisted pair cables are
required. One twisted pair, is the PC's TXD channel, it carries the
data sent from the PC's TXD outputs to the RXD inputs of each of
the RS485 devices. The second twisted pair, is the Devices TXD
channel, it carries the data sent from each of the devices' TXD
outputs to the RXD inputs of the PC.
The advantages of this system are great, since no new
communications, software is needed, and the PC can talk and listen
at the same time. In effect, the handshaking is performed by the
intelligence of the RS485 devices attached to the PC.
When wired as in Figure 4-6 below, the PC can transmit data at
any time and all the RS485 devices #1 to #n simultaneously
receives it.
Only one of the RS485 devices may talk, i.e. transmit data,
at any one time. Each RS485 device recognizes commands and
data addressed to it, it only talks when the PC commands it to do
so. When the RS485 device receives the command to talk from the
PC, it gates its TXD drivers on, sends the data down the device
The RS485 devices only drive their TXD lines
Chapter 3 Page 60
Software Setup

Advertisement

Table of Contents
loading

This manual is also suitable for:

1 port pci velocity rs4221 port pci velocity rs485

Table of Contents