Heartway Medical Products S12X Manual page 24

14.Buttons
ITEM
Button
General Display Mode
(TRIP)
Setting Mode
Escape from Setting
Mode
Operation Status
Remarks
SPECIFICATION
"MODE" switch
M
SET for 3 seconds to reset TRIP at "00.0".
Press
O
Press MODE and
Mode", then 『Hour：MIN』start flashing.
D
(1) When『Hour』flashing:
E
Press SET to increase of number, then press
『MIN』.
(2) When『MIN』flashing:
Press SET to increase of number, then press
『km/h & mph』.
(3) When 『km/h』 or 『mph』flashing
SET to choose "km/h" or "mph" type, then press .MODE
Press
Mode" of 『C / F』
(4) When『C』or『F』flashing
SET to choose C or F .
Press
Under setting mode, if below situations happened, will auto save the last setting value then
escape to general operation mode.
(1) No any operation of ADJ button for 20 sec.
(2) Press MODE and
(1) 『Hour：Min』,『km/h』or『mph』,『C』or『F』offer Cyclical Switch function.
(2) When adjusting 『Hour：Min』, press
more than 2 seconds, the number will increase continuously until button released, setting
value with Cyclical Switch function (only 2 seconds from 0 to 9).
* If『Hour』less than 10, the denary "0" doesn't display.。
Button tones: one short "Bi" sound
Function set
SE
T
SET simultaneously for more than 2 seconds. to enter "Setting
SET at same time for more than 2 sec.
SET to increase number, if press
24
to enter "Setting Mode" of
MODE
to enter "Setting Mode" of
MODE
to enter "Setting
SET for