Table of Contents
Advertisement
M3 Sonar FLS Installation Manual
a
Check the applicable weight certificate for the truck.
b
Check the limitations for lifting height and angles.
c
Pay special attention to the position of the unit's centre of gravity.
d
Make sure that the unit is properly secured to the truck during the lifting and
transportation operations.
5
Handle all units and boxes with care.
Note
Due to the nature of Kongsberg Mesotech's products, and the extensive use of delicate
electronic parts, all units and boxes must be regarded and handled as fragile equipment.
Inspection of units and transportation boxes
after arrival
A visual inspection must be done immediately after the box(es) have arrived at their
destination.
Prerequisites
If you suspect that the equipment has been damaged during the transport, request that a
representative of the carrier is present during the inspection.
Procedure
1
Check all boxes (wooden or cardboard boxes, plastic bags and/or pallets) for physical
damage.
Look for signs of dropping, immersion in water or other mishandling.
2
If external damage is detected, open the box to check its contents.
Request that a representative of the carrier to be present while the box is opened, so any
transportation damage can be identified and documented.
3
If a unit has been damaged, prepare an inspection report stating the condition of the
unit and actions taken.
Describe the damage, and collect photographic evidence if possible. Return the
inspection report to Kongsberg Mesotech as soon as possible.
4
If units are not damaged, check the humidity absorbing material.
If required, dry or replace the bags, then re-pack the unit(s) according to the packing
instructions.
84
922-20297011/1.0
Advertisement
Table of Contents
