Connecting The Power Supply; Table 6 Legend For The Connection Example - Beckhoff CX8110 Manual

5.2

Connecting the power supply

Damage to the Embedded PCs
The Embedded PCs may be damaged during wiring.
• The cables for the power supply should only be connected in de-energized state.
The power supply terminals require an external voltage source, which provides 24 V DC (-15% / +20%). The
power supply terminal must provide 4 A at 24 V, in order to ensure the operation of the Embedded PCs in all
situations.
The cabling of the Embedded PC in the control cabinet must be done in accordance with the standard EN
60204-1:2006 PELV = Protective Extra Low Voltage:
• The "PE" and "0 V" conductors of the voltage source for a basic CPU module must be on the same
potential (connected in the control cabinet).
• Standard EN 60204-1:2006, section 6.4.1:b stipulates that one side of the circuit, or a point of the
energy source for this circuit must be connected to the protective earth conductor system.
Connection example
Us 24 V (DC)
X001
X101
X102
S101
Up 24 V (DC) Terminal-Bus
Table 6: Legend for the connection example
No. Description
1 The upper spring-loaded terminals identified with "24 V" and "0 V" supply the Embedded
PC and the terminal bus (data transfer via K-bus or E-bus).
2 The spring-loaded terminals identified as "+", "-" and "PE" supply the Bus Terminals via
the power contacts and the sensors or actuators connected to the Bus Terminals.
CX8110
CX8110
TC
WD
ERR
24V 0V
+ +
- -
PE PE
Version: 1.4
NOTE
1
2
Commissioning
23