Table of Contents
Advertisement
STEP 3: Loosen the screws from the lid and remove. Route the ignition cable through the cable gland.
STEP 4: Flip the emitter and canopy over. Align the burner with the holes in the canopy. Attach the burner
using (2) #10-24 hex nuts.
STEP 5: The gas control arm comes equipped with the manifold bracket pre-attached using a v-clamp and
#10-24 screw. Prior to assembly, rotate the manifold bracket as shown without loosening the screw.
Form No. 43539510
–6–
May 2020
Advertisement
Table of Contents
