Installing The Light Kit - HAMPTON BAY DEVEREAUX II Use And Care Manual

Assembly — Installing the Light Kit
Attaching the light kit to
13
the mounting plate
CAUTION: Before starting installation, disconnect the
power by turning off the circuit breaker or removing the fuse
at the fuse box. Turning power off using the fan switch is not
sufficient to prevent electric shock.
□
Remove four screws (PP) from the mounting plate (G)
and keep it for future use.
□
While holding the light kit (H) under your fan, locate
two single white and blue wires in the mounting plate
labeled "FOR LIGHT". Make the polarized plug
connections (QQ):
- White to white
- Blue to black
□
Carefully push all wires back into the mounting plate
(G). Install the light kit (H) onto the mounting plate (G)
with the four light kit mounting screws (PP) provided.
Be sure to tighten all screws.
G
H
QQ
PP
TT
Installing the light bulbs
14
and glass shade
CAUTION: Before starting installation, disconnect the
power by turning off the circuit breaker or removing the fuse
at the fuse box. Turning power off using the fan switch is not
sufficient to prevent electric shock.
□
Install the 2 x 9.5W LED bulbs (CC) (included).
□
Remove the decorative nut (RR) and plastic nut (SS)
from the light kit stem (TT). Raise the glass shade (I)
up against the light kit (H), place the plastic nut (SS)
over the light kit stem (TT) and turn it clockwise until it
locks up against the light kit stem (TT). Do not
overtighten.
□
Raise the glass frame (J) up to the glass shade (I) and
secure it to the light kit stem (TT) with the decorative
nut (RR).
□
Restore power and your light kit (H) is ready for
operation.
CC
15
Please contact 1-855-HD-HAMPTON for further assistance.
TT
H
I
SS
J
RR
HAMPTONBAY.COM