HAMPTON BAY DEVEREAUX II Use And Care Manual page 12

Assembly — Hanging the Fan (continued)
8
Installing the canopy
WARNING: Make sure the tab on the mounting bracket (A)
properly sits in the groove in the hanger ball / downrod
assembly (D) before attaching the canopy (B) to the mounting
bracket (A) by turning the canopy until it drops into place.
□
Make sure connections are neatly tucked into the
ceiling outlet box.
□
Slide the canopy (B) up to the mounting bracket (A)
and place the key hole on the canopy (B) over the
loose canopy mounting screw (FF) on the mounting
bracket (A). Turn the canopy (B) clockwise until the
canopy (B) locks in place at the narrow section of the
key holes.
□
Align the circular hole on the canopy (B) with the
remaining hole on the mounting bracket (A). Secure
the canopy mounting screw (FF) previously removed
in the hole and tighten the two canopy mounting
screws (FF).
FF
C
9
□
A
B
FF
12
Attaching the canopy
bottom cover
NOTE: Adjust the canopy mounting screws (FF) as
necessary until the canopy (B) and canopy bottom cover (C)
are snug.
Attach the canopy bottom cover (C) to the canopy
mounting screw heads on the bottom of the
(FF)
canopy (B) by inserting the screw heads into the key
slots in the canopy bottom cover (C) and rotating the
canopy bottom cover (C) clockwise.
B
FF
C