Shuttle FS58 Manual page 68

Init Display First
This item is used to determine initial device when system power on.
Ø The choice: PCI Slot or AGP/Onboard.
Onboard Super IO Device
Options are in its sub-menu.
Press <Enter> to enter the sub-menu of detailed options.
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDC) in-
stalled on the system board and you want to use it. If you install add-on
FDC or the system has no floppy drive, select Disabled in this field.
Ø The choice: Enabled or Disabled.
Onboard Serial Port1
Select an address and corresponding interrupt for the first and second
serial ports.
Ø The choice: 3E8/IRQ4, 2E8/IRQ3, 3F8/IRQ4, 2F8/IRQ3,Auto, or
Disabled.
UART Mode Select
This item allows you to select which mode for the Onboard Serial Port.
Ø The choice: Normal, IrDA, ASKIR or SCR.
UR2 Duplex Mode
This item allows you to select the IR half or full duplex function.
Ø The choice: Full or Half.
Onboard Parallel Port
This item allows you to determine onbaord parallet port controller I/O
address setting.
Ø The Choice: 378/IRQ7, 278/IRQ5, 3BC/IRQ7 or Disabled.
Parallel Port Mode
Select an operating mode for the onboard parallel(printer) port. Select
Normal,Compatible, or SPP unless you are certain your hardware and
software both support one of the other avaukable modes.
Ø The Choice: SPP, EPP, ECP or ECP + EPP.
ECP Mod Use DMA
Select a DMA channel for the parallel port for use during ECP mode.
Ø The Choice: 1 or 3.
- 63 -