Chapter 17 For Dos User (For Mfc-9070 Only); How To Use The Mfc With Your Dos Application Software; What Does The Remote Printer Console Do; Installing The Remote Printer Console - Brother MFC-9030 Owner's Manual

17
For DOS User

How to Use the MFC with Your DOS Application Software

Before working with your application software that runs on DOS, check that the machine's name
appears in the printer selection of your application software. If the machine is not listed, you must
install the printer driver that corresponds to HP LaserJet 5P's emulations.
The following table shows the combination of printer driver and emulation mode. To get the most
out of this machine, you should install an HP printer driver in your application software.
Printer driver supported in your application
software
HP LaserJet 5P
• Be sure to choose the proper printer driver in your application software.
• Be sure the printing resolution is set to 600 dpi in your DOS application software.

What Does the Remote Printer Console Do?

The Remote Printer Console (RPC) is a utility program that can run in the DOS environment:
This program allows you to change various printer settings such as emulation, print quality, fonts,
page setup etc., from your computer screen. Since most DOS applications have a Printer Settings
menu that overrides the settings made by the RPC, you may not have to use this utility program. This
utility program is useful for application software that does not control the printer's settings and
features.

Installing the Remote Printer Console

Before you install the program, make sure you have the following hardware and software to install
the program:
DOS
Monitor
Option
Follow these steps to install the remote printer console program:
1
Make sure the machine is connected to your computer.
2
Start your computer and go to the DOS prompt. If you are in Windows
DOS prompt.
3
Insert the Brother CD-ROM into your CD-ROM drive (substitute your appropriate drive letter
for "X").
4
At the DOS prompt (C:\>) type X: (X is the letter of your CD-ROM drive) and press Enter.
C:\>X:
5
Type CD DOS and press Enter.
X:\>CD DOS
™
Version 3.3 or later
EGA/VGA or compatible
Mouse; the mouse driver must be installed.
(You can also operate the program with the keyboard.)
(For MFC-9070 Only)
Emulation mode to be selected with the remote
printer console program
HP LaserJet 5P emulation mode
For DOS User (For MFC-9070 Only)
®
, exit and return to the
117