JDS Uniphase SKB Series User Manual page 77

62 Commands
SWAP_CHANNEL
Swap channel designations between two optical fibers. This command can be used to
Description
reorder channels that have been swapped
Switch, Output1, Output2
Parameters
Switch (unsigned eight-bit)--switch number
Parameter
Output1 (unsigned eight-bit)--first output channel
Description
Output2 (unsigned eight-bit)--second output channel
Command packet
OPCODE Length
0x34 0x03
Parameters
U8 Switch, U8 Output1, U8 Output2
Switch (unsigned eight-bit)--Logical switch number (1 to 4)
Output1 (unsigned eight-bit)--The first output channel (1 to 200)
Output2 (unsigned eight-bit)--The second output channel (1 to 200)
This command resets the switch.