Table of Contents
Advertisement
LEARN?
Query command(s) required to return the switch to current state following reset. This
Description
query returns the information required to send the switch back to the state it was in prior
to reset.
NA
Parameters
NA
Parameter
Description
Command packet
OPCODE
Length
0x24
0x00
Response packet
OPCODE
Length
0xA4
0x05 to
1
0x14
1.
The length is variable, depending on the number of switches in the module.
(1-5) (U8 Opcode, U8 Len, U8 Sw_Id, U8 Cur_In, U8 Cur_Out)
Opcode (unsigned eight-bit)--"SWITCH" command opcode (0x20)
Sw_Id (unsigned eight-bit)--Switch number (1 to 4)
Cur_In (unsigned eight-bit)--Current input channel of the switch (1 to 2)
Cur_Out (unsigned eight-bit)--Current output channel of the switch (0 to 200)
Parameters
Parameters
Commands
53
Advertisement
Table of Contents
