Channel Switching Times
The time to a sequential channel (for example, going from channel two to three) can appear to be
greater than the specification for the adjacent channel. This discrepancy can be due to a few rea-
sons:
•
If the user has used the REPLACE command to replace a damaged channel, that channel is not
sequential. Management of the switching order can be done using the SWAP_CHANNEL com-
mand.
•
The factory configuration can be such that a channel was deliberately skipped.
Confirming Time Between Channels
The SKB switch allows the user to confirm the specified time to switch between channels. The
CONNECTION_TIME? query physically checks the time by switching between the start and destina-
tion channel. The query output is the time as calculated using the internal clock.
Introduction
9