Table of Contents
Advertisement
3 | Safety and compliance
3.1 | Safe handling
•
An unpopulated enclosure can weigh up to 46kg (101lb). Use appropriate lifting methods.
•
A fully populated enclosure weighs 135kg (298lb). You must lift the enclosure when the
drawers are empty and latched closed. Do not attempt to lift the enclosure when populated
with drives.
•
When closing the drawers, do so firmly, ensuring the latches are engaged.
•
Please use belt straps to lift the enclosure out of the box.
•
Do not try to lift the enclosure by yourself.
•
Use appropriate lifting methods. Before lifting the enclosure:
Remove DDICs drive carriers from drawers and verify the drawers are closed and firmly
o
locked.
Use a minimum of three people to lift the enclosure using the lifting straps provided.
o
Avoid lifting the enclosure using the handles on any of the CRUs because they are not
o
designed to take the weight. Lift from underneath the main enclosure.
•
Observe the lifting hazard label affixed to the storage enclosure.
3.2 | Safety
•
This equipment is for installation in a Restricted Access Location only.
A restricted access location is where:
Access can only be gained by service persons or users who have been fully instructed on
o
the reasons for the restrictions applied to the location and on any precautions that must
be taken.
Access is through the use of a tool or lock and key, or other means of security, and is
o
controlled by the authority responsible for the location.
Caution
If this equipment is used in a manner not specified by the manufacturer, the
manufacturer warranty provided by the equipment may be impaired.
•
All drives and rear modules are part of the 5U84 storage enclosure and must only be removed
when a replacement can be immediately added. The system must not be run without all rear
modules in place.
•
Permanently unplug the enclosure before you move it or if you think that it has become
damaged in any way.
•
Always remove the drives, Power Supply Units (PSUs), controllers, and System fans to
minimize weight before you move the enclosure.
•
A safe electrical ground connection must be provided to the power supply cords.
Important
The enclosure MUST be grounded before applying power.
Lyve Rack R1 Installation Guide
7
Advertisement
Table of Contents
Need help?
Do you have a question about the Lyve Rack R1 and is the answer not in the manual?