Skipping The Countdown Time; Taking Less Than Three Measurements - Microlife WatchBP Office ABI Instruction Manual

Skipping the countdown time

The 60 seconds countdown before measurement in
«SCREEN» Mode and 15 seconds in «ROUTINE» Mode
can be skipped by pushing the Start/Stop Button.
While the Start/Stop Button is pushed, the device will
immediately begin the next measurement.
Skip the countdown time
and begin measurement.
The device can be set into Stand-by Mode by pressing
*
the Start/Stop Button after the completion of
measurements. The device will automatically switch to
Stand-by Mode if left unattended for ive minutes.
Stand by mode

Taking less than three measurements

The measurement sequence can be stopped
at anytime by pushing the Start/Stop Button
«SCREEN» Mode or «ROUTINE» Mode. The device
enters stand-by and the remaining measurements
are cancelled. Average of the measurements is
saved and can be viewed by pushing the M Button.
Cancel remaining
measurements at
anytime during
the measurement
sequence.
21
EN