Table of Contents
Advertisement
PROBLEM
3. No product is being
dispensed.
4. The product is too soft.
Models C709 & C717
PROBABLE CAUSE
a. Low on mix. The MIX
OUT light is on.
b. The power switch is in the
OFF position.
c. The circuit breaker is off
or the fuse is blown.
d. Beater motor is out on
reset, BEATER
OVERLOAD message
displayed.
e. Machine not in AUTO
mode.
f. Feed tube not properly
installed.
g. Freeze-up in mix inlet
hole.
h. The beater is rotating
counterclockwise when
observed from the
operator end.
a. Draw rate is set too fast.
b. Not enough air space
around unit. (Air cooled
units)
c. Worn scraper blades.
d. Dirty condenser (A/C)
e. Mix is out of date.
f. Loss of water. (W/C)
g. Viscosity needs
adjustment.
49
REMEDY
a. Add mix to the mix hopper.
Return to AUTO mode.
b. Place the power switch to ON
and select AUTO.
c. Turn the breaker on, or
replace the fuse.
d. Turn the machine off. Press
the reset button. Restart the
machine in AUTO.
e. Select AUTO and allow
machine to cycle off before
drawing product.
f. Make sure feed tube is
properly installed.
g. Call an authorized service
technician.
h. Contact service technician to
correct rotation.
a. Adjust draw rate of 5 to 7 1/2
oz. (142 g. to 213 g.) of
product by weight in 10
seconds.
b. Allow for adequate air flow
across the condenser.
c. Replace regularly.
d. Clean monthly.
e. Use only fresh mix.
f. Locate cause of water loss
and correct.
a. Contact service technician.
Troubleshooting Guide
PAGE
REF.
39
38
- - -
- - -
42
39
- - -
- - -
33
1
52
46
- - -
47
- - -
Advertisement
Table of Contents
Troubleshooting
