Mirrors
6
Adjusting mirrors
64
z
Move mirror to the desired po-
sition by turning it.
Adjusting mirror arm
Slide protective cap 1 up over
screw connection on mirror
arm.
Loosen the nut 2.
Turn mirror arm into desired
position.
Tighten the nut to the spec-
ified torque while holding the
mirror arm to ensure that it
does not move out of position.
Locknut (mirror) on
clamping piece
Joint compound: Multi-Wax
Spray
Locknut (mirror) on
clamping piece
15 lb/ft (20 Nm)
Slide protective cap over
threaded fastener.
Headlight
Adjusting headlight for
RHD/LHD traffic
If the motorcycle is ridden in a
country where vehicles are driven
in the opposite lane relative to
your own country, its asymmetric
low-beam headlight will tend to
blind oncoming traffic.
Have the headlight adjusted for
these conditions by an authorized
service facility, preferably an au-
thorized BMW Motorrad retailer.