GRAPHTEC FC4200-50 Service Manual page 14

NAMES OF THE MAIN PARTS
Menu Keys
PAUSE key: Press this key to enter Menu mode and light its green lamp. Press it again to
cancel Menu mode and turn off the lamp. Press this key when you wish to proceed to set a
function. If the plotter receives data after this key is pressed, it will temporarily store the data
in its data buffer.
ENTER key: Press this key to register the selected setting when specifying a function. In
Pause status, you can reset the plotter by concurrently pressing the ENTER and ORIGIN
keys.
ORIGIN key: Used to change the position of the coordinate systemʼs origin point. When
the automatic detection of registration marks is enabled, press this key to initiate automatic
detection.
COPY key: Used to repeat the cutting operation defined by the data in the plotterʼs buffer.
CONDITIONS key: Press this key to change any of the cutting conditions appearing on the
plotterʼs display panel.
TEST key: Press this key to run a test to check whether the currently selected cutting
conditions are suitable for the medium loaded.
NEXT PAGE key: Press this key during Menu mode to proceed to the next menu page.
CANCEL/VIEW key: During a cutting operation, press this key to immediately stop cutting.
While the Ready message is being shown on the plotterʼs display panel, press this key to
move the pen outside of the maximum cutting/plotting area. To return the pen to its original
position, press this key again.
FC4200-UM-251-03-9370 9