Table of Contents
Advertisement
Chapter 2
g
Close the output paper tray cover.
Check that the paper is flat in the tray
and below the maximum paper mark (1).
h
Slowly push the paper tray completely
into the machine.
CAUTION
DO NOT push Tray #1 into the machine too
quickly. Doing this may cause injury to your
hand by trapping it between Tray #1 and
Tray #2. Please push Tray #1 in slowly.
i
While holding the paper tray in place,
pull out the paper support (1) until it
clicks, and then unfold the paper
support flap (2).
12
1
2
1
Note
If you are finished using Ledger, Legal or
A3 size paper and want to use a smaller
paper size, take the paper out of the tray.
Then shorten the tray by pressing the
universal guide release button (1).
Adjust the paper length guide (2) to fit the
paper size you are going to use. Then put
the paper into the tray.
2
1
1
Advertisement
Table of Contents
