Setting Up From The Cpu Link System; Figure 5-5 Cpu Link System Startup Dialog Box; Figure 5-6 Pcs Edition Dialog Box (Initial State) - Hitachi S10mini CPU LINK Hardware Manual

5.4.2 Setting up from the CPU link system

① Start the CPU link system. The CPU link system, when started, opens the dialog box shown
below. Do not click the "Transfer system program (S)" button. The system program used to
run the CPU link module is contained in the module itself.
Do not transfer the system program. If the system program is transferred, the
built-in program in the CPU link module may get out of control, causing invalid
data to be transmitted or CPU internal memory to be altered. If the system
program is transferred by mistake, reset the CPU module for recovery.
② Click the "PCs edition (E)" button to see the following dialog box open:
Area that is set up for the
module used as main link
Area that is set up for the
module used as sublink

Figure 5-5 CPU Link System Startup Dialog Box

Figure 5-6 PCs Edition Dialog Box (Initial State)

5 SETUP AND OPERATIONS
NOTE
5-7