CAM (Channel Activity Monitor) function
Up to 10 groups with 5 channels each, of frequently used memory channels* may be
registered, and then while receiving the current frequency, the status (signal strength)
of the selected group of memory channels may be displayed. It is easy to identify on
which channel the communication was made. When a memory channel on the graph is
touched, it will become the center operating frequency, so communication with friends
may begin immediately (TOUCH & GO Operation).
Memory channel tag
Memory channel number
currently selected
CAM Group tag display
Touch the bar graph, it will
be the transmit/receive
frequency.
When frequencies other than 108MHz to 580MHz (i.e.: shortwave broadcasting; AM/FM
radio; 50MHz band; etc.) are registered to CAM, a gray bar graph is displayed. Touch the bar
graph to switch to the receive frequencies and hear the signals.
Register memory channel to CAM group
1. Press the [F menu], and then touch [CAM].
• If [CAM] is not displayed, touch [FWD ] to display
[CAM] and then touch it.
• The CAM screen is displayed.
The CAM function only uses memory channels, while the
PMG function can register both VFO frequencies and
memory channels.
2. Touch [GROUP], and then turn the DIAL knob to select
the group (GROUP 01 to 10) to be registered.
36
YAESU
CAM Group selection
Currently selected memory channel
(displayed in orange)
Display in gray even if the received signal is lost
CAM memory channel tag display
Gray bar graph is displayed for frequencies
outside the frequency range (108 to 580 MHz)
that can be displayed as a bar graph.