Installation; Appropriate Installation Location - Grundig GRNE4653 User Manual

3 Installation

3.1 Appropriate installation
location
Contact an Authorized Service for
the installation of the product. In
order to prepare the product for use,
refer the information in the user
manual and ensure that electrical
installation and water installation are
appropriate. If not, call a qualified
electrician and technician to have
any necessary arrangements carried
out.
B
B
B
12
WARNING:
Manufacturer shall
not be held liable for
damages that may
arise from procedures
carried out by
unauthorized persons.
WARNING:
Product
must not be plugged
in during installation.
Otherwise, there is
the risk of death or
serious injury!
WARNING:
If the
door clearance of
the room where the
product shall be
place is so tight to
prevent passing of
the product, remove
the door of the room
and pass the product
through the door by
turning it to its side;
if this does not work,
contact the authorized
service.
• Place the product on an even floor
surface to prevent jolts.
• Install the product at least 30 cm
away from heat sources such as
hobs, heater cores and stoves and
at least 5 cm away from electrical
ovens.
• Product must not be subjected to
direct sun light and kept in humid
places.
• Your product requires adequate air
circulation to function efficiently.
If the product will be placed in
an alcove, remember to leave at
least 5 cm clearance between the
product and the ceiling, rear wall
and the side walls.
• If the product will be placed in
an alcove, remember to leave at
least 5 cm clearance between
the product and the ceiling,
rear wall and the side walls.
Check if the rear wall clearance
protection component is present
at its location (if provided with
the product). If the component
is not available, or if it is lost or
fallen, position the product so that
at least 5 cm clearance shall be
left between the rear surface of
the product and the wall of the
room. The clearance at the rear is
important for efficient operation of
the product.
• Do not install the product in places
where the temperature falls below
-5°C.