Page 2
Please read this manual first! Dear Customer, We hope that your product, which has been produced in modern plants and checked under the most meticulous quality control procedures, will provide you with effective service. For this, we recommend you to carefully read the entire manual of your product before using it and keep it at hand for future references.
Important instructions for safety and environment • Always have repairs carried out by the This section contains safety instructions that will Authorised Service Agent. The manufacturer help protect from risk of personal injury or property shall not be held liable for damages that damage.
Important instructions for safety and environment 1.1.2 For products with • Flammable items or products that contain flammable gases (e.g. spray) as well as the a water dispenser explosive materials should never be kept in the • Pressure of water mains should be minimum 1 appliance.
Important instructions for safety and environment 1.6 Package information Packaging materials of the product are manufactured from recyclable materials in accordance with our National Environment Regulations. Do not dispose of the packaging materials together with the domestic or other wastes. Take them to the packaging material collection points designated by the local authorities.
Installation 3.1. Appropriate Always have the repair procedures carried out by installation location the Authorised Service Agent. Manufacturer shall not be held liable for damages that may arise from WARNING: If the door of the room where procedures carried out by unauthorised persons. the product will be placed is too small for To make the product ready for use, make sure the product to pass, then the product's...
Installation • The specified voltage must be equal to your mains voltage. • Do not make connections via extension cables or multi-plugs. WARNING: Damaged power cable must Authorised be replaced by the Service Agents. WARNING: If the product has a failure, it should not be operated unless it is repaired by the Authorised Service Agent! There is the risk of electric shock!
Installation 3.6. Door open warning 3.8. Connecting the water (This feature is optional) hose to the refrigerator An audio warning signal will be given when the 1. Slip the union (b) onto the water hose (a). door of your product is left open for 1 minute. This 2.
Installation 3.9. Connecting of the water hose to the cold water mains line (This feature is optional) If you will use the refrigerator by connecting it to the cold water mains line, you must install a standard 1/2" valve connector to the cold water installation of your home.
Installation 3.11. Mounting the external filter onto the wall 1. First, determine the location to mount the external filter. 2. Then, determine the distance between the filter and the tap and filter and the water inlet respectively. Prepare hoses at required lengths. 3.
Installation 3.12. Things to do to have If the filter usage time is calculated the filter usage time automatically, Filter Change Warning calculated automatically indicator will illuminate continuously in a few seconds after the product is plugged (For products connected to the mains water line and equipped with filter) Automatic filter usage time calculation is 1.
Installation • Do not consume the first 30 pieces (3-4 Liters) • Do not attempt to clean the ice container of ice cubes. assembly without removing it from the • First several glasses of water may be cloudy refrigerator. when the filter is used for the first time. 3.14.
Preparation 4.1. Things to be done 4.3. Recommendations on for energy saving the fridge compartment • Do not allow the food to touch the Connecting the product to electric energy temperature sensor in fridge compartment. saving systems is risky as it may restrict To allow the fridge compartment to keep its operation of the product.
Page 16
Preparation • Run the refrigerator without putting any food for 6 hours and do not open its door unless absolutely necessary. You will hear a noise when the compressor starts up. The liquids and gases sealed within the refrigeration system may also give rise to noise, even if the compressor is not running and this is quite normal.
Operating the product 5.1. Indicator panel Indicator panels may vary according to the product model. 1. Freezer compartment temperature setting 2. Economy mode 3. Error status 4. Cooler compartment temperature setting 5. Rapid cooling 6. Vacation function 7. Keypad lock / filter replacing alert cancellation 8.
Page 18
Operating the product 1. Freezer compartment temperature setting Press the vacation function button again to cancel this function. ( Pressing the button ( ) number (1) will enable the freezer compartment temperature to be set at 7. Keypad lock / Keypad lock / filter replacing -18,-19,-20,-21 ,-22,-23,-24,-18...
Operating the product 5.2. NeoFrost Cooling System • Pack the food in an airtight manner to prevent them from drying even if they are going to be Thanks to the two separate cooling systems, stored for a short time. cooling speed is much faster than traditional •...
Operating the product 5.4. Recommendations for Divide the food into portions according preserving the frozen food to your family's daily or meal based • Frozen food that you have purchased should consumption needs. be stored in accordance with the frozen food Pack the food in an airtight manner to manufacturer's instructions for a prevent them from drying even if they are...
Operating the product 5.11. Odour filter 5.7. Chiller compartment *optional *optional Odour filter prevents unpleasant odour build-up in The chiller compartment maintains a lower temperature then the rest of the fridge, ideal for your refrigerator. storing fresh meat fish and deli items. Odour filter can be located in the fridge You can increase the inner volume of your compartment on the back wall.Pull the cover into...
Operating the product 5.12. Using the dispenser *optional The water and ice dispenser will provide chilled water and ice either direct from your water supply It is normal for the first few glasses of water taken from the dispenser to be warm if not used for a long time.
Operating the product 5.14. Drip tray Important: Components of the water tank and water dispenser *optional should not be washed in dishwasher if the glass Water that dripped while using the water dispenser tank is plastic. Glass water tanks can be cleaned in accumulates in the spillage tray.
Operating the product 5.15. Icematic and ice 5.16. Ice-maker storage container (Optional) *optional Ice maker is located on the upper section of the Using the Icematic’ freezer cover. Fill the Icematic with water and place it into its Hold the handles on the sides of the ice stock seat.
Page 25
Operating the product If you have difficulty in refitting the reservoir, turn the rotary gear 90° and reinstall it as shown in the figure3. Any sound you hear when the ice drops into the reservoir is a part of normal operation. When the ice dispenser does not work properly If you do not remove ice cubes for a long time, they will cause formation of ice chunks.
Maintenance and cleaning Cleaning your fridge at regular intervals will • Keeping the refrigerator clean is important. extend the service life of the product. Food residuals, stains, etc. can cause odour. Therefore, clean the refrigerator with bi- WARNING: Unplug the product before carbonate dissolved in water every few months.
Page 27
Maintenance and cleaning Remove the glass water tank with its case by holding it from both sides and remove it with an angle of 45°C. Clean the glass water tank by removing its case. Remove the hose connecting cover. Do not fill the water reservoir with any other liquid except for water such as fruit juices, carbonated beverages or alcoholic drinks which are not suitable to use in...
Troubleshooting Please review this list before calling the service. It will save your time and money. This list includes frequent complaints that are not arising from defective workmanship or material usage. Some of the features described here may not exist in your product. The refrigerator does not operate.
Page 29
Troubleshooting • The freezer temperature is adjusted to a very low value. >>> Adjust the freezer temperature to a warmer degree and check Fridge temperature is very low while the freezer temperature is sufficient. • The fridge temperature is adjusted to a very low value. >>> Adjust the fridge temperature to a warmer degree and check.
Page 30
Troubleshooting • No regular cleaning is performed. >>> Clean the inside of the refrigerator regularly with a sponge, lukewarm water or carbonate dissolved in water. • Some containers or package materials may cause the smell. >>> Use a different container or different brand packaging material.
GUARANTEE DETAILS Your new Grundıg product is guaranteed against the cost of breakdown repair for 5 years from the date of the original purchase. Please visit www.grundig.co.uk to register your warranty What is covered? • Repairs necessary as a result of faulty materials, defective components or manufacturing defect.
Page 32
Otherwise please call the appropriate number above where service can be obtained at a charge. Should you experience any difficulty in obtaining service please contact the Grundig Customer Help-Line. Tel: 0845 603 1234 or 0345 603 1234...
Need help?
Do you have a question about the GSBS 13310 X and is the answer not in the manual?
Questions and answers