Advertisement
ASSEMBLY
Essentially the Mortarman
750MBP is fully assembled and ready to operate when it leaves the assembly
®
facility here at IMER U.S.A. However there are a couple items which should always be checked before
towing and operating the Mortarman
750MBP.
®
1. Retrieve the dump handle from inside the drum and thread it into the dump gate mechanism.
2. Make sure each tire is inflated to 40 lbs. PSI.
3. Make certain the retractable stability legs are raised up fully and locked in place with the anchor pin
and safety clips provided.
4. Make certain that the tow bar is properly anchored and its tow chain is in place. It is also important to
loop the tow chain around the tow bar several times before connecting it to the vehicle.
5. Make sure the engine canopy door is latched shut.
6. Make certain that the hitch system on your car or truck is compatible to the tow bar tongue.
7. Finally, local laws and ordinances vary from state to state regarding the registration of towable
construction equipment.
Check with your local Department of Motor Vehicles for the proper procedure to follow.
NOTE: State law may also require a tail light assembly.
Advertisement
