Advertisement
To lower the machine, proceed as follows:
1) Extract the lifting foot [1] (fig. 1) from the lateral housing.
2) Remove the lifting foot [1] and position it on the rear side of the machine, in the vicinity of the roll bar [7].
3) Raise the lifting foot [1] by means of the handwheel [4] until the upper bracket [11] can be inserted below the
roll bar [7] and centred.
4) Turn the handwheel [4] again so that the rear legs [R] no longer touch the ground.
5) Remove leg locking pins [10], removing the relative cotter pins [9], to lower the legs [R] to the ground.
6) Turn handwheel [4] again to lower the machine until the hole on the leg supports (SR) is aligned with the
4th hole (starting from the bottom) on each leg [R].
7) Insert locking pins [9] and secure in position by means of cotter pins [10].
8) Remove the lifting foot [1] and use the handwheel [4] to lower the machine until the lower bracket [8] can be
inserted below the roll bar [7] and centred.
9) Turn the handwheel [4] again so that the rear legs [R] no longer touch the ground.
10) Remove leg locking pins [9], removing the relative cotter pins [10], to lower the legs [R] to the ground.
11) Turn handwheel [4] again to lower the machine until the hole on the leg supports (SR) is aligned with the
3rd hole (starting from the bottom) on each leg [R].
12) Insert locking pins [9] and secure in position by means of cotter pins [10].
13) Remove the lifting foot [1] and position on the other side of the machine (front) in front of the drive hole [2]
and lower the foot [1] until pin [3] is aligned with hole [2], by means of the handwheel [4].
14) Insert pin [3] in the drive hole and turn handwheel [4] to raise the machine until the front legs [F] are
detached from the ground.
15) Remove locking pins [5] of legs [F], removing the relative cotter pins [6], to lower the legs to the ground.
16) Turn handwheel [4] again to lower the machine until the hole on the leg supports (SR) is aligned with the
3rd hole (starting from the bottom) on each leg [F].
17) Insert locking pins [5] and secure in position by means of cotter pins [6].
18) Remove the lifting foot [1] and return to the lateral housing.
Advertisement
