Soilviewer Troubleshooting; Opticmapper Or Ph Controller Is Not Found - Veris 3150 MSP3 Operating Instructions Manual

Pub. # OM20-MSP3-3D
Procedure #8 SoilViewer Troubleshooting

OpticMapper or pH controller is not found

Check to ensure the com which the EC Surveyor/OpticMapper is connected to is present under the
device manager. To get to the device manager go to StartSettingsControl PanelSystem
Click on the Hardware tab and then click on the device manager button. Click on the "+" sign next
to Ports and make sure the port is listed here. In this case a USB to serial converter is being used
and the port is listed as USB Serial Port (COM33)
Figure 8.1
If the port is not listed here, then unplug and replug the USB – Serial converter cable and ensure
the power is on to the EC surveyor. If USB – Serial port is still unavailable then reinstall the drivers
following the manufactures instructions for driver installation.
6-19