Hubs - Veris 3150 MSP3 Operating Instructions Manual

Figure 3
Hubs --Use good quality wheel bearing or lithium grease for lubrication, but we suggest that you
grease the hubs sparingly. Over-lubricating the hub will result in pre-mature seal failure, and an
excessive amount of grease in the hub cap/commutator. On an interval of 150 hours, 1-2 strokes
of grease should be sufficient.
 Pinch point hazard: to prevent injury, stand clear when raising or lowering any part of the
Veris MSP3-3D.
 Install all transport locks before transporting or working underneath.
 Always use the service stands when working underneath the MSP3/3D.
Figure 5
grease zerk
Figure 4
Figure 6
5-2
Pub. # OM20-MSP3-3D