Mapping With Soilviewer; Soilviewer Startup Display - Veris 3150 MSP3 Operating Instructions Manual

Attach the pH serial communication cable to an available COM port on your computer. Connect EC
signal cable and power cords to ports on rear of VSense Controller, connect the GPS to the GPS
in of the OM Comm. cable, then connect the serial output of the OM Comm. to any available COM
port on your computer using a standard serial cable. If serial port is not available on PC, then a
USB to Serial converter can be used with the VSense Controller provided the drivers for the
converter are installed and functioning properly.

SoilViewer startup display

Figure 52
Figure 53

Mapping with SoilViewer

4-26
Select either 3150 (2
depth EC Systems) or
3210 (3 Depth EC
Systems)
To acquire EC, OM and
pH data select Acquisition
Pub. # OM20-MSP3-3D