The MSP3-3D electronics kit shown below.
MSP3/3D EC
Test Box
pH
Simulator
SoilViewer
Keep all diagnostics and operations manual with system when mapping.
The supplied GPS(Figure 2) is configured to operate
with the MSP3/3D electronics.
The use of any other GPS requires the correct
settings. The GPS needs to output only two NEMA
strings(GGA and VTG OR RMC). The system will
not run with more than two strings. The strings
need to output at 4800 baud and 1Hz refresh rate.
Section 2
Electronics Overview and Set-up
Figure 1 MSP3-3D electronics kit
2-1
OM Reference
Block
Figure 2
Pub. # OM20-MSP3-3D
MSP3-3D EC
test load
OM test
load
USB Serial
Adapter