Lighting System; Interior Lighting; Exterior Lighting; Heating And Ventilation System Cabin Heating - Beechcraft Bonanza V35B Pilot Operating Handbook

LIGHTING SYSTEM

INTERIOR LIGHTING

Lighting for the instrument panel is furnished by a light in the cabin ceiling. It is controlled by the INST
switch on the Light Control Panel.

EXTERIOR LIGHTING

The switches for all of the exterior lights are located on the Light Control Panel. The exterior lights
consist of navigation lights and landing lights. For longer battery and lamp life, use the landing lights
sparingly; avoid prolonged operation which could cause overheating during ground maneuvering.

HEATING AND VENTILATION SYSTEM CABIN HEATING

A heater muffler on the left exhaust stack provides for heated air to five outlets in forward and aft areas
of the cabin. Two forward outlets are located above and forward of each set of rudder pedals. One aft
outlet is installed behind the right front seat. Two outlets provide heated air for windshield defrosting.
HEATER OPERATION
The forward vents, located on the firewall forward of the rudder pedals, deliver heated air to the forward
cabin when the CABIN HEAT control is pulled out. For maximum heat the control is pulled fully out.
To obtain increased heated air for defrosting the windshield close the toe-pedal type valves at the front
hot air outlets.
CABIN VENTILATION
In moderate temperatures, ventilation air can be obtained from the same outlets used for heating, by
pushing the CABIN HEAT control full forward.
The Light Control Panel is located on the switch panel on the lower
section of the pilot's instrument panel.
The cabin heat control is located on the lower pilot's
subpanel. To obtain heated air to the cabin outlets, pull the
CABIN HEAT control. The control regulates the amount of
cold air that is mixed with the air from the heater muff.
When the control is pulled fully out, the cold air is shut off
and only heated air enters the cabin.
- 31 -
Beechcraft V35B Bonanza
Pilot Operating Handbook