Before Take-Off; Take-Off; Climb; Cruise - Beechcraft Bonanza V35B Pilot Operating Handbook

BEFORE TAKE-OFF

1. Parking Brake - SET
2. Radios - CHECK
3. Engine Instruments - CHECK
4. Flight Instruments - CHECK and SET
5. Throttle - 1900 RPM
6. Propeller - Hold Propeller Control Switch in LO RPM position until a decrease in RPM is noted,
and then hold switch to HI RPM until RPM is regained.
1. Check Automatic Propeller Control by moving propeller switch to the AUTO position and
turning APC knob full left until RPM starts to decrease, then turn knob to the Take-Off
position (full right),
7. Magnetos - CHECK at 1600 rpm. Drop should not exceed 75 rpm on either magneto, and
should be within 50 rpm of each other.
8. Carburetor Heat - CHECK and return to COLD
9. Trim - SET
a. Aileron - NEUTRAL
b. Elevator - 00 (30 nose down for aft loading)
10. Flaps - UP
11. Door and Windows - SECURE
12. Seat Belts and Shoulder Harnesses - SECURE
NOTE
All reclining seats must be in the upright position during take-off.
13. Controls - FREE
14. Mixture - FULL RICH (or as required by field elevation)
15. Brakes - RELEASED
16. Instruments - CHECK, make final check of manifold pressure, fuel pressure, and rpm at the
start of the take-off run. Oil temperature less than 215°F.

TAKE-OFF

Take-Off Power (B35)
(1 min.)
1. Power - SET TAKE-OFF POWER AND RELEASE BRAKES
2. Airspeed - ACCELERATE TO RECOMMENDED SPEED
3. Landing Gear - RETRACT (when positive rate of climb is established)
4. Airspeed - ESTABLISH DESIRED CLIMB SPEED (when clear of obstacles)
5. Propeller - 2050 rpm.

CLIMB

Climb Full throttle, 2050 rpm
1. Engine Temperatures - MONITOR
2. Power - SET AS DESIRED.

CRUISE

1. Cowl Flaps - CLOSED
2. Power - SET
3. Mixture - ADJUST
Full throttle, 2450 rpm
- 20 -
Beechcraft V35B Bonanza
Pilot Operating Handbook