Starting - Beechcraft Bonanza V35B Pilot Operating Handbook

WARNING
Do not take off if gauges indicate in yellow arc or with less than 10 gallons in each main tank.
12. Activate the selector valve several times by rotating the handle from tank to tank to ensure
that the se• lector valve is free.
13. Fuel Selector Valve - SELECT LEFT MAIN TANK.

STARTING

CAUTION
Vernier-type engine controls should not be rotated clockwise after being advanced to the full forward
position.
1. Mixture - FULL RICH
2. Propeller - HI RPM
NOTE
On governor equipped propeller, switch in AUTO and governor control at TAKE-OFF.
3. Throttle - OPEN (2 or 3 turns of vernier.)
4. Ignition Switch - BOTH
5. Auxiliary (wobble) Fuel Pump - Pump and maintain 9 to 10 P.S.I.
6. Starter Button - Press until engine starts.
7. Primer - Brief shots until engine starts firing
NOTE
If a false start occurs or the starter button is released after the ignition switch has been turned to the
BOTH position, the ignition switch must be turned to the BATT position before the starter button will
again energize the starter.
NOTE
If starting fuel pressure is low, maintain pressure with auxiliary (wobble) fuel pump until pressure
stabilizes.
8. In the Event of Overprime Condition:
a. Mixture - IDLE CUT -OFF
b. Throttle - OPEN
c. Starter Button - PRESS
d. As engine starts reduce throttle to IDLE and advance mixture to FULL RICH
9. Oil Pressure - CHECK
10. External Power (if used) - DISCONNECT. Battery and Generator Switches ON.
11. Warm up - 1000 to 1200 rpm.
NOTE
Do not operate engine above warm-up speed until oil temperature reaches 100°F (38°C).
12. All Engine Indicators - CHECK
13. Avionics Equipment - AS REQUIRED
14. Lights - AS REQUIRED
- 19 -
Beechcraft V35B Bonanza
Pilot Operating Handbook