Table of Contents
Advertisement
Available languages
Available languages
B
A
(Figure 6)
(Figure 7)
B
(Figure 8)
34 - PAE85T / Operating instructions
4.2 MACHINE INSTALLATION
It is forbidden to install this machine in ex-
plosive environments.
It must be installed in a place that provides all the necessary
guarantees. Keep in mind the following:
• The dimensions of the parts being processed.
• There must be a minimum of 1 metre of free space around
the machine.
• The floor surface must be as flat as possible, and the machi-
ne must be supported on it at 4 points.
• Electrical and pneumatic power supply connections must
be nearby.
• A dust collection connection (industrial, unless equipped
with a Virutex AS382L dust collector) must be available.
• The lighting must be adequate for the work performed
(approx. 500 LUX).
4.2.1 Fastening the machine to the floor
The machine is equipped with non-slip adjustable legs, but
to avoid an accident, it is advisable to fasten the machine to
the floor.
To fasten the machine to the floor, rest the machine on its
module unit and attach it to the ground using the four holes
(B) and locking and expansion bolts, not supplied with the
machine. (Fig. 6)
C
4.3 RELEASING PARTS
Some parts are locked in place to prevent
damage during shipping.
To release them, proceed in this manner:
4.3.1 Releasing trimmer parts
• Cut and remove the flanges that hold the adjustable guide
and the protective clamp cover (Fig. 7)
Open the protective cover (C).
• Cut and remove the flange that locks the trimmer arm (Fig.
8)
Turn the control knobs (D) to their respective ends to release
the trimmer arm. Turn the top control knob clockwise and the
bottom control knob counterclockwise.
Advertisement
Chapters
Table of Contents
