Entering The Names For The Heating Circuits; Changing The Standard Menu - Viessmann VITOTRONIC 300 Operating Instructions Manual

Further Adjustments
Entering Names for the Heating Circuits

Changing the Standard Menu

24
You can give heating circuits 1, 2 and 3 ("HC1", "HC2"
and "HC3") individual names. The abbreviations "HC1",
"HC2" and "HC3" will be retained.
Extended menu
1.
2. "Settings"
3. "Name for heating circ."
4. "Heating circuit 1", "Heating circuit 2 or "Heating
circuit 3"
5. "Change?"
6. You can select the required symbol with
7. takes you to the next character.
8. Press OK to accept all entered characters at once
and simultaneously exit this menu.
Note: The entered term is deleted with "Reset
"Heating circuit 1" will then be shown again.
Example:
Name for "Heating circuit 1": Ground floor
If your heating system has several heating circuits, you
can select the heating circuit to be displayed in the
standard menu (see chapter "Menu").
Note: If there is only one heating circuit, this menu is not
available. No heating circuit designation "HC..." is
shown in the header.
Extended menu
1.
2. "Settings"
3. "Standard menu"
4. Select the heating circuit:
H "Heating circuit 1" Display in the header: "HC1"
H "Heating circuit 2" Display in the header: "HC2"
H "Heating circuit 3" Display in the header: "HC3"
Vitotronic 300, GW5B Operating
.
?
";